IC-7300 Rig Control – Beta Test Version

This beta version of the IC-7300 Rig Control program is being released to experienced users willing to help test the software and report problems. Your feedback will help improve the program before the final release.

Beta Tester Instructions

Step 1 – Download the program
Download the ZIP file using the button below.

Step 2 – Extract the files
Unzip the downloaded file before running the program.

Step 3 – Connect your radio
Install the Icom USB driver if it is not already installed.
Connect your IC-7300 to the computer using a USB cable.

Step 4 – Check the COM port
Open Windows Device Manager and verify which COM port was assigned to the IC-7300.

Step 5 – Run the program
Start the program and select the correct COM port.

Step 6 – Testing
Operate the program normally and report any problems or suggestions.

Beta Software Notice

This software is unfinished and provided for testing purposes only. Unexpected behavior may occur, but most likely will not. Use caution when transmitting and always monitor your station.

Program: IC-7300 Rig Control

Version: Beta 3

Platform: Windows

File: IC7300Beta.zip

Download IC-7300 Rig Control (Beta 3) with Installation Instructions Download IC-7300 Rig Control (Beta 3) EXE and ShortCut only